RAM Laptop Mount for F-150 and F-250: Fit and Setup Guide

By RAM® Mounts | Best Phone, Tabletand Laptop Mounts for Cars and ... | Published: 2026-10-19

Category: How-to Guides

Learn how to fit and install the RAM Laptop Mount in your Ford F-150 or F-250. Step-by-step instructions for a secure, work-ready setup.

Quick Answer

The RAM Laptop Mount for 2015-2026 Ford F-150 and 2017-2026 Ford F-250 installs using existing seat bolts and a bracket that fits under the passenger seat. Follow these steps to secure it properly.

What You Need Before Starting

The RAM Laptop Mount (Legacy design) is built for specific Ford trucks: 2015-2026 F-150 and 2017-2026 F-250. It does not fit other models without modification. Check your truck's year and model against the compatibility list before purchasing.

The mount uses a bracket that attaches to the floor under the passenger seat. You will need a socket wrench, a torque wrench, and a few minutes of clear workspace. No drilling or permanent alterations are required.

Common Installation Mistakes

Incorrect seat bolt torque is the most frequent error. Too loose and the mount shifts; too tight and you risk stripping the threads. Always use a torque wrench set to the vehicle manufacturer's specification for seat bolts.

Another mistake is routing the laptop tray arm too close to the seat adjustment lever. Leave at least an inch of clearance so the seat can move freely without pinching cables or the arm.

Installation Steps

Remove the Passenger Seat: Slide the passenger seat fully forward. Using a socket wrench, remove the four bolts securing the seat to the floor. Carefully tilt the seat backward (do not disconnect any wiring if present) and set it aside on a clean surface. Check for any wiring harnesses under the seat before tilting it back to avoid damage.
Position the Mount Bracket: Place the RAM mount bracket over the rear two seat bolt holes. The bracket's slotted holes should align with the bolt holes. Insert the two bolts that came with the mount and hand-tighten them. Do not fully tighten yet; you may need slight adjustment to align the laptop tray arm.
Reinstall the Seat and Torque Bolts: Carefully reposition the passenger seat over the bracket. Insert the two front seat bolts. Using a torque wrench, tighten all four seat bolts to the Ford-specified torque (typically 35-45 ft-lb; check your owner's manual). Over-torquing can strip the threads or damage the seat frame. Use the correct torque value.
Attach the Laptop Tray Arm: Slide the vertical arm into the bracket's receiver and tighten the knob. Attach the laptop tray to the arm using the provided hardware. Adjust the arm angle so the tray sits level and within easy reach of the driver. Ensure the arm does not interfere with the seat's forward/backward travel before final tightening.
Test for Stability and Clearance: Sit in the driver's seat and reach for the laptop tray. Adjust the arm position if needed. Move the passenger seat through its full range of motion to confirm nothing binds or rubs against the mount. If the seat hits the arm or tray, reposition the arm or adjust the bracket alignment before final use.

Product Details

RAM® Laptop Mount for '15-26 Ford F-150, ’17-26 F-250 + More (Legacy): Compatible with 2015-2026 Ford F-150 and 2017-2026 Ford F-250 and other models. This narrow compatibility means you must verify your truck's year and model to avoid a return.
RAM® Laptop Mount for '15-26 Ford F-150, ’17-26 F-250 + More (Legacy)